Description
Weighing Auto Feeder(Loss-in-Weight)
This is the Loss in Weight type Grametric Constant Feeder.
A load cell with a platform scale has been adopted and control unit is equipped with a highly reliable programmable controller.
Therefore operation part with intensifier display, it can be changed setting and indicated any data to operate button on display.
Also it is economical because plural feeders controlled by one PLC at the same time
Attention : It includes some special specification at this picture
Features
LOSS IN WEIGHT TYPE (PLATFORM SCALE TYPE)
GRAMETRIC CONSTANT FEEDER FOR POWDER (STEP DISC TYPE)
- Accuracy of the feed rate is guaranteed with +-0.5～1% of whole
setting range. - An accurate and steady feeding rate with the FUNKEN AUTO
FEEDER is possible even during the refiling period. - Continuous measurement and indication of bulk density during the
operation. - Continuous display and record of powder flow rate
Loop Conveyor Scale(Mass Flow Meter)
It has two knife edges, one on each end of the fulcrum axis, and the inlet
and outlet of the loop conveyor are located near these knife edges.
Thus, only the weight of powder passing through the left half can be detected by the load cell.
From the detected weight and the revolution speed, the flow rate of the powders is calculated and the flow rate signal is emitted accordingly.
Loop conveyor is bilateral – symmetrical construction.
The fixed passing route is scraped by impeller so tareweight is always balanced. And also it can detect only powder weight on the left half continuously without zero point shift.
This Loop Conveyor Scale must be combine with Funken Auto Feeder.
Features
